Search results

Create the page "Serial" on this wiki! See also the search results found.

• Open Lighting Architecture
  || [http://www.doityourselfchristmas.com/wiki/index.php?title=Renard Renard Serial Protocol (Renard SS24, SS8, etc)] || [[Image:Trans.gif|center]] || ? || ? |
  10 KB (1,449 words) - 15:10, 24 March 2016
• DMX USB Pro
  ...45BM, so VCP (virtual com port) drivers make programming easy as opening a serial port and sending/receiving! Earlier units did not have serial numbers programmed and this may affect the ability of certain applications
  2 KB (249 words) - 11:02, 26 July 2013
• Open DMX USB
  The OpenDMX USB is based on a FT232BM chip, a USB to Serial converter produced by FTDI.
  1 KB (201 words) - 09:18, 28 June 2011
• OLA Device Specific Configuration
  Enable the FTDI driver (ola-ftdidmx ) and disable the USB Serial and Open DMX drivers (ola-usbserial.conf & ola-opendmx.conf) ...ing else using the serial port; either use raspi-config (Advanced Options, Serial) or follow the instructions here:
  13 KB (2,018 words) - 13:31, 22 May 2019
• USB DMX
  * Compatible with all major O/S (refers to driver for USB to serial interface)
  1,017 bytes (162 words) - 11:04, 10 June 2009
• PMX2DMX
  [[Category:Serial]]
  413 bytes (70 words) - 00:32, 7 January 2007
• Linux ArtNet Node
  # cp dmx_usb_module/dmx_usb.ko /lib/modules/2.6.X-Y-386/kernel/drivers/usb/serial/dmx_usb.ko # rm /lib/modules/2.6.X-Y-386/kernel/drivers/usb/serial/ftdi_sio.ko
  5 KB (876 words) - 03:20, 25 April 2012
• RDM
  ...assigned a 6 byte UID comprising of a 2 byte manufacturers ID and a 4 byte serial number. It is used to identify all devices on a universe (enumeration proce
  1 KB (184 words) - 03:52, 12 October 2013
• DMX512-A
  DMX is based on the balanced serial connection standard [http://en.wikipedia.org/wiki/EIA-485 EIA-485-A] (a.k.
  9 KB (1,553 words) - 03:55, 12 October 2013
• Products
  * [[:Category:Serial| Serial port interface]]
  1 KB (130 words) - 09:15, 9 May 2011
• LLA, OpenDMX USB and Q Light Controller Tutorial
  sudo cp ./dmx_usb.ko /lib/modules/$(uname -r)/kernel/drivers/usb/serial ===Blacklist the other serial drivers===
  11 KB (1,874 words) - 14:12, 1 September 2016
• ArtNet
  DMX is a serial protocol, so it sends data one bit at a time over the wire. Each DMX cable
  3 KB (569 words) - 07:15, 9 December 2009
• E1.31
  Entertainment Technology -- USITT DMX512-A -- Asynchronous Serial Digital Data Transmission Standard for Controlling Lighting Equipment and A
  2 KB (324 words) - 00:03, 4 December 2013
• OLA Command Line Tools
  Serial: 02050016
  2 KB (318 words) - 09:28, 24 July 2013
• DMX PIPE
  It seems that this interface consists of a USB-to-serial converter from FTDI-chip and a level converter,much like the Enttec [[Open
  1 KB (246 words) - 12:34, 27 August 2010
• OLA developer info
  * Save a given combination of devices (just by type or with unique ID's from serial numbers, USB device ID's etc) The serial number is is decoded (from 4 bit Binary Coded Decimal) in lla-usbpro, not t
  26 KB (3,973 words) - 05:55, 31 December 2017
• Arduino RGB Mixer
  * Serial number (UID) can be set remotely The newer Ardiuno boards auto-reset when the serial connection is established which causes problems with OLA. To disable the au
  5 KB (756 words) - 19:35, 1 March 2014
• USB Protocol Extensions
  === USB Serial Number === Enttec USB Pro devices have only started programming the serial numbers recently (>2008?).
  3 KB (499 words) - 17:01, 22 November 2013
• Open Lighting PIDs
  This sets the serial number of the device. The serial number is combined with the ESTA ID to create the UID.
  738 bytes (116 words) - 19:48, 12 August 2017
• Cinetix
  ...erfaces made by Cinetix provide communication via an open, well documented serial-, [[MIDI]]-, USB- or ethernet connection with a computer or any equipment e
  1 KB (177 words) - 14:47, 22 May 2012

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)